To create a custom Serial Orthosis
Select the components from the Individual Components table. Each Orthosis requires a distal and a proximal cuff, based on the measurements of the limb, and corresponding cuff straps. Each Orthosis also requires two sidebars, based on the measurement of “L”, and a Pad.
|
|
|
|
|
|
|
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
The cuff size is half the circumference of the limb. For example a CUFF7 will fit a 14” circumference limb. The circumference should be measured at the upper and lower mid points of the limb. |
|
These polished stainless steel bars are supplied in pairs. Side Bar length is set by extending the limb to its fullest extension, then |
|
The pads are soft and shape to the limb. The Velcro strap can be trimmed to length. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
Product Brochure |  |
Where to Buy |